Drainage Works: SPUD GUN (AKA - SPUDZOOKA) + HOW TO MAKE!

วันเสาร์ที่ 11 กุมภาพันธ์ พ.ศ. 2555

SPUD GUN (AKA - SPUDZOOKA) + HOW TO MAKE!

READ BELOW ON HOW TO MAKE! No powertools or torch NEEDED!!! + visit: www.P2Productions.com SPUD GUN / POTATO GUN / SPUDZOOKA Warning: For use only if u are under parental supervision* AND DO NOT BE AN IDIOT AND RUIN IT FOR THE REST OF US BY SHOOTING THESE AT PEOPLE OR ANY LIVING CREATURE! How to make a SPUD GUN-- *PARTS* ---------------------------- Kitchen Lighter - (aka BBQ Lighter) 2 drywall screws ---------------------------- PVC or ABS cement (note: do NOT mix PVC pipes with ABS pipes or fitting, only use PVC cement on PVC and ABS on ABS) ---------------------------- 2 feet of 2 inch diameter PVC or ABS pressure rated pipe 1 foot of 3 inch diameter PVC or ABS pressure rated pipe slip to threaded 3 inch fitting 3 to 2 in reducer end cap (screw off ) for 3 inch pipe (note: clean out plug may be used) ---------------------------- hair spray - or RAID works plenty of spuds (or apples) ---------------------------- *ASSEMBLY!* 1. Cut pipes to correct length's with a hacksaw 2. Glue the barrel and the chamber to the reducer as shown in the diagram. (if PVC is used don't forget to apply primer first. 3. Close off the end of the chamber with the fitting and screw-on end cap or the drain plug cap. 4. Screw the drywall screws through the sides the combustion chamber so there is about a 1/4 to 3/8 inch gap 5. Connect the sparker to the drywall screw and make sure it fires properly, if no spark fires move screws closer and re-test. 6. Bevel the end of the barrel so that the ...